GeoVision How do I setup spot monitor?
GeoVision
Back to GeoVision Support | Support Home
Back to GeoVision Support | Support Home
Spot monitor is available for GV1120, GV1240, GV1480, GV3008, and GV4008.
Enable Spot Monitor
Enable Spot Monitor
- In Multicam, go to Configure, Accessories, DSP Spot Monitor, Spot Monitor Setup, then check "Use DSP as Spot Monitor at next Startup".
- Click "OK".
- Select the Power button, Restart Multicam, Restart by Startup Settings.
- After reboot, go to Configure, Accessories, DSP Spot Monitor, Spot Monitor Controller, then configure spot monitor settings.
