Setting up Network configuration guide 1-1.

Check List, before doing this step:

* Make sure you have a screen attached to your DVR or NVR system. By ( HDMI, VGA or RCA).

* Make sure there is a Network cable attached from DVR or NVR system to router.

* Make sure a mouse is attached to your DVR or NVR.

* Make sure all device are powering up (DVR or NVR), Screen display, and router

1. Right click and select the (Main Menu ) option.

2. A (System Login) should prompt, asking for Username & password
Note: the Default Log in should be:
User Name: 888888 / Password: 888888

3. Once you are logged in, select (Setting)

4. Then select (Network)

Once in (Network), select the (DHCP) option.
Note: box should turn white

5. After selecting (DHCP), now select the (SAVE).

6. Exit completely of all the Menu, until back on the camera display
Note: by right clicking on the mouse should exit.

7. Right click and select the (main Menu ) option

8. A (System Login) might prompt, asking for Username & password
Note: the Default Log in should be:
User Name: 888888 / Password: 88888

9. Once on the Menu again, Select( Setting)

10. Then select (Network)

11. Once in Network, write the following info
� IP address: ex: 192.168.1.116
� Gateway 192.168.1.1
� http Port 80
� TCP Port 37777
� UDP Port 37778

12. After having all the info, written down. Un select the (DHCP)
Note: make sure all the info stay the same, or make match with the info you have written.

13. Then go ahead and select (Save).

Exit completely of all the Menu, until back on the camera display
Note: by right clicking on the mouse should exit.

15. Now go to: Setting up Network configuration 1-2 Guide